Your browser version is too low, it may lead to sites not normally access!
You can use the site to function properly, use these browsers.
First, try to use the sealant, you can use the paint to achieve the ideal sealing effect;
Second, the rubber seal should be carefully checked for appearance quality before assembly; use special tools to press fit to avoid knocking deformation;
Third, fill the lubricating grease according to the regulations, and regularly clean the venting holes and check valves;
Fourth, the assembly is carried out under extremely clean conditions, and the working surface of the parts is free from bumps, scratches, burrs and other attachments;
Fifth, strict operating procedures, seals should be properly installed to prevent deformation in place;
Sixth, master the performance specifications and use requirements of the seals, and replace the failed parts in time;
Seventh, for the thin-walled parts of the side cover, the sheet metal is used for cold correction; the shaft hole parts that are easy to wear can be metallized, welded, glued, machined, etc. to achieve the original size;
8. The nut slide wire is broken and loose, and the new piece should be repaired or replaced, and screwed to the specified torque.